Run every 10 minutes for non-syslog based datasources.įollowing a successful import, the security log data for the datasource is accessible in the Available Datasources section of Spotter. Run every 1 minutes for datasources with the collection method as syslog. Select Do you want to schedule this job for future? in the Job Scheduling Information section and select any of the following based on the collection method: Specify the User Attribute, Operation, Parameter, Condition, and Separator parameters in the Correlate events to user using rule section.Ĭlick Save in the lower-right corner of the page to save the Correlate events to user using rule table.Ĭlick Save & Next in the upper-right corner of the page. Note: For more information on Identity Attribution, refer to the SNYPR 6.4 Data Integration Guide. Provide a descriptive name for the correlation rule in the Correlation Rule section. Identity attributionĬlick Add Condition > Add New Correlation Rule to add a correlation rule. Note: For more information on Parser Management, refer to the SNYPR 6.4 Data Integration Guide. Parser Name: SCNX_JUNIPE_JUNIPERSRXFIREWALL_IFW_SYS_KEY_COMM.The following image is just for reference:įor Juniper SRX Firewall, you have to select the following information: Select By Vendor from Choose Existing Parser.Ĭlick Vendors > Resource Types > Parser Name. Review and select the existing parser, or you can search for another parser by performing the following steps: The Select Timezone drop-down list is displayed. In the right section of the screen, select a resource and click Select Timezone. Select a resource or any number of resources to view details on the right-section of the screen. Review discovered devices to locate devices that you want to onboard. Note: Note: You can locate a datasource/device by specifying CIDR or keyword in the Search field. The section displays a list of discovered devices by recommended parsers. Specify timezone for activity logs: Select a time zone from the list.Ĭlick Get Preview in the upper right corner of the page to preview the ingested data from the datasource.įollow the following steps if you are using SNYPR 6.4:Ĭlick Discovered.Datasource Name: Enter Juniper SRX Firewall. Note: The IP address is the address of the host initiating the traffic.Ĭomplete the following information in the Device Information section: Perform the following steps in the Ingesters section:Ĭlick + to add a filter for the ingester, and then provide the following information:Īdd the following syslog expression to identify events that are associated with the device: Click Add Data > Add Data for Supported Device Type to setup the ingestion process.Ĭlick Vendor in the Resource Type Information section and select the following information:.Navigate to Menu > Add Data > Activity in the SNYPR application. On the Remote Ingester Node, verify if we are receiving logs using the command below :Ĭomplete the following steps to configure #Vendor #Product in the SNYPR application:įollow the following steps if you are using SNYPR 6.3.1: Navigate to Logging/Count and in Log Options, select Log at Session Close Time.Įnabling logging for security policy using CLIĮxecute the following set security policies from-zone trust to-zone untrust policy permit-all then log session-close Select Configure > Security > Policy > FW Policies.Ĭlick on the policy for which you would like to enable logging. Click Configure > CLI Tools > Point and Click CLI.Ĭlick Add New Entry in the Host section of the Syslog page (bottom-right),Įnter the IP address of the Remote Ingester Node (RIN) Sensor.Įnabling logging for security policy using JWeb
0 Comments
Leave a Reply. |